HP StorageWorks 8/80 Brocade Fabric OS Command Reference Guide v6.1.0 (53-1000 - Page 482

2 portCfgNPIVPort portCfgNPIVPort Enables or disables N_Port ID virtualization (NPIV) functionality on a port. Synopsis [slot/]port,mode Description Use this command to enable or disable NPIV functionality on a port. NPIV is only applicable to F_Ports. The following conditions must be met for a switch port to respond to NPIV requests from an NPIV device: NPIV capable: NPIV capability is a switch blade or port attribute that is required for NPIV functionality to operate. Some blades within a switch, or some ports within a switch or blade, might not have NPIV capability. NPIV functionality cannot be enabled on such ports and they do not respond to NPIV requests. NPIV enabled: NPIV functionality must be enabled on a port for it to respond to NPIV requests. By default, NPIV is enabled on all Condor and Golden-eye-based ports. It can be selectively enabled or disabled on switch ports using this command. NPIV HA: For a redundant control processor (CP) system to enable NPIV functionality, it must be running NPIV-enabled firmware versions on both the active and standby CPs. This requirement does not apply to single CP systems. Up to a maximum of 255 virtual port IDs are allocated per NPIV port. The maximum number of virtual IDs can be configured from 0 to 255 per port. The default value is 126 per port. The number of virtual port IDs per switch can be configured with the configure command. Note Changes made by this command are persistent across switch reboots and power cycles. Use the portCfgShow command to determine whether NPIV is enabled on a port. Use the portCfgDefault command to reset all port configurations, including the NPIV configuration of a port. The execution of this command is subject to Admin Domain restrictions that may be in place. Refer to chapter 1, "Understanding Admin Domain Restrictions" and Appendix A, "Command Availability" for details. Operands This command has the following operands: slot For bladed systems only, specify the slot number of the port to be configured, followed by a slash (/). port Specify a port number to be configured, relative to its slot for bladed systems. Use switchShow to display a list of valid ports. mode Specify 1 to enable and 0 to disable the NPIV function. Examples To enable NPIV functionality on a port: switch:admin> portcfgnpivport 1/3 1 456 Fabric OS Command Reference 53-1000599-02