Lexmark C782 Service Manual - Page 119

5061 Step B Step 1 2 3 Actions and questions Check Tray 1 for damage to the pick arm lift bellcrank activation tabs on the rear of the tray. Is there any damage to the tray? Check the following parts for damaged, loose, or missing parts. • Pick arm lift bellcrank • Bellcrank lift spring • Tray interlock bellcrank Are any of the parts broken, loose, or missing? Verify the autocompensator is not stuck in the up position (tires or hub caught on the deflector gate) Yes Replace tray 1. No Go to step 2 Repair or replace parts as necessary. Go to step 3 Dislodge the autocompensator assembly. Replace the autocompensator pick assembly. See "Autocompensa tor pick assembly removal" on page 4-27. Step C Step 1 2 Actions and questions Can you remove Tray 1 from the printer? Open the lower jam access door, carefully lift the autocompensator assembly until it is in its uppermost position, and carefully try to remove tray 1. Can you remove Tray 1? 3 Check Tray 1 for damage to the pick arm lift bellcrank activation tabs on the rear of the tray. Is there damage to the tray? 4 Check for loose or broken parts on the autocompensator assembly. Are there loose or broken parts? 5 Check the following parts for any signs of damaged or broken parts. • Pick arm lift bellcrank • Pick arm bellcrank lift spring Are there any damaged or broken parts? Yes Go to step 3 Go to step 3 Replace tray 1 No Go to step 2 Determine what is causing the tray to stay in a locked position. Repair as necessary. Go to step 4 Replace the autocompensator assembly. See "Autocompensa tor pick assembly removal" on page 4-27. Repair or replace parts as necessary. Go to step 5 Determine what is causing the autocompensator to stay in the down position. Repair as necessary. Diagnostic information 2-77