Lexmark C782 Service Manual - Page 299

Rear roll Reach around and depress the latch (A) on the end of the shaft, and remove the roll. 5061 Installation note for the rear roll: • When replacing both the front and back rolls, note the directional markings on the roll and make sure the rolls turn clockwise when viewed from the front. Check out the directional arrows in the pictures. Verify the rolls turn freely. • Once the pick arm assembly is lowered, the spring is disengaged. To properly position the pick arm assembly and re-engage the spring: 1. Reach through the lower jam access door opening, and lift and hold the pick assembly in the proper position. 2. Press the autocompensator release lever (B) to engage the spring. Note: A piece of paper is shown in the picture only for contrast. Repair information 4-71