Lexmark C782 Service Manual - Page 71

5061 200.04 paper jam service check S2 sensor late Note: See "Printer sensors" on page 5-3. Step 1 2 Actions and questions Check the tray for proper edge guide setting and media loading. Edge guides should be adjusted against edge of media. Media should be fanned and lay flat in the tray. Is the media properly loaded in the tray? Check the pick tires for contamination or wear. Are pick tires worn or contaminated? 3 Check for obstructions in the paper path. Is the paper path obstructed? 4 Is the inner deflector out of position? 5 Is the autocompensator damaged or defective? 6 Perform the "BASE SENSOR TEST" on page 3-24 on the S2 sensor. Does the S2 sensor pass the test? Yes Go to step 2 No Properly load media. Replace the pick rolls. See "Pick rolls removal" on page 4-70. Clear the obstruction. Go to step 3 Go to step 4 Correct the inner deflector position. Go to "Autocompensa tor service check" on page 2-76 Contact your next level of support. Go to step 5 Go to step 6 See "200.21, 200.28, and 200.29 paper jam service check. 200.05 paper jam service check S2 or narrow media sensor did not break in time Note: See "Printer sensors" on page 5-3. Step Actions and questions 1 Make sure the media installed in the tray meets specifications. Does the media meet specifications? Yes Go to step 2 2 Check tray for the edge guide setting and media loading. Edge guides should be adjusted against edge of media. Media should be fanned and lay flat in the tray. Is the media properly loaded in the tray? 3 Remove the ITU, and check for the jam at the second transfer roll. Is paper jammed at the second transfer roll? Go to step 3 Clear the jam. No Inform the customer that media loaded in Tray x does not meet specification Properly load media. Contact your next level of support. Diagnostic information 2-29