Pioneer VSX-49TX Owner's Manual - Page 17

10 Auto Surround Setup •Connect microphone •Please be quiet •Move obstacles away •If you have a subwoofer turn power on and turn volume up [Start] [Cancel] \ Auto Surround Setup Please Wait Caution!! Test tone is output loudly. [Cancel] \ Auto Surround Setup Now Analyzing••• Environment Check Ambient Noise Microphone Speaker Level [OK] [OK] [OK] [Cancel] \ 11 Check!! FRONT [ YES ] CENTER [ YES ] SURROUND [ YES ] SURR BACK [ YESX2] SUB WOOFER [ YES ] [OK,Go Next] [Retry] [ERR Fix SP.] [Return to Menu] Auto Surround Setup Now Analyzing••• Surround Analysis Speaker Systems Speaker Distance Channel Level Acoustic Cal EQ [OK] [OK] [OK] [OK] [Cancel] Speaker Systems Check " Normal Surround " FRONT [ SMALL ] CENTER [ SMALL ] SURROUND [ SMALL ] SURR BACK [SMALLX2] SUB WOOFER [ YES ] [Next] ( Back/Next ) [Return] Quick Start Guide Part2 9 Some auto setup instructions will be listed, make sure to follow them. Make sure you have: hooked up the microphone and moved obstacles to the speakers out of the way. If you have a subwoofer make sure it is turned on and has the volume turned up. WARNING: The test tones are very loud!! Make sure there are no infants or small children in the room and that no one who will be scared, upset or injured by loud noise is present. You yourself may want to wear earplugs. If you lower the volume of test tones with the master volume, the result will likely be incorrect speaker settings. 10 If you have followed all setup instructions and warnings above make sure that the arrow is pointed to START and press ENTER. Be prepared for loud test tones. Try to be as quiet as possible after hitting ENTER. The test tones may take up to 30 seconds. The volume automatically increases to 0dB, then the system will output some test tones and establish ambient noise levels, the microphone status, and what speakers you hooked up. 11 Check the speaker settings on the OSD If they match your speaker configuration make sure OK,GO NEXT is selected and press ENTER. The system will output another series of test tones to establish the proper channel level, speaker distance and acoustic calibration EQ. Again, be prepared for loud test tones. The test tones may take up to 5 minutes this time. After it has finished, you see the SPEAKER SYSTEMS CHECK screen. If you want to view the settings select NEXT and press ENTER repeatedly. If not, simply go to step 13. If they do not match the speaker configuration you hooked up and you want to try again select RETRY with 5∞ buttons and press ENTER. Follow the instructions above from step 10. If the speaker settings do not match the speaker configuration you connected and you want to input the settings manually select ERR=FIX SP with the 5∞ buttons, press ENTER and go to step 12. If you see an ERR message in the right side column, there may be a problem with the speaker connection. If selecting RETRY doesn't fix the problem, turn off the power and check the speaker connections. 17 QUICK START GUIDE