Ricoh CL7200 Setup Guide - Page 207

Preparing for Printing • PCL 5c D:\DRIVES\PCL5C\WIN2K_XP\(Language)\DISK1 • PCL 6 D:\DRIVES\PCL6\WIN2K_XP\(Language)\DISK1 • PostScript 3 D:\DRIVES\PS3\WIN2K_XP\(Language)\DISK1 When installation is complete, the printer connected to "1394_00n" appears in the [Printers and Faxes] window. ("n" shows the number of printers connected.) F Follow the instructions. ❒ If the printer driver has already been installed, the printer icon is added to the [Printers and Faxes] window. In this case, printer driver installation is not necessary. ❒ Even if the printer driver is already installed, the message " Found New Hardware Wizard" may appear when the printer and the computer are connected using the IEEE 1394 interface cable for the first time. If it does, install the printer driver. ❒ If printing does not work properly after the installation, delete the port and reinstall the printer driver. For details, see "Printer Does Not Print", Maintenance Guide. ❒ If you do not want to install the printer when Found New Hardware Wizard starts under an operating system that supports SCSI print, disable the device by following the procedure below A When the [Found New Hardware Wizard] dialog box appears, check that [This wizard helps you install software for: Unknown] displayed, select [Install from a list on specific location (Advanced)] check box, and then click [Next >]. B When the message "Please choose your search and installation option." appears, clear all check boxes from [Search for the best driver in these locations.], and then click [Next >]. C When the message "The wizard could not find the software on your computer for." appears, click [OK]. D When the message "Cannot Install this Hardware" appears, select the [Don't prompt again to install the software] check box, and then click [Finish]. 67