Ricoh CL7200 Setup Guide - Page 380

Monitoring and Configuring the Printer • You can specify the interval at which the printer synchronizes with the operator-specified NTP server. The default is 60 minutes. • The interval can be entered between 16 and 16,384 minutes. • If you set 0, the printer synchronizes with the NTP server only when you turn the printer on. After that, the printer does not synchronize with the NTP server. ❖ Time-zone configuration msh> sntp timezone "+/-hour_time" • You can specify the time difference between the printer clock and NTP server clock. Time is in 24-hour format. spoolsw Use the "spoolsw" command to configure Job Spool settings. You can only specify diprint, lpr, ipp, ftp and smb protocol. • The "spoolsw" command for configuring Job Spool settings is available only when the hard disk is installed. ❖ View settings The Job Spool setting appears. msh> spoolsw ❖ Job Spool setting msh> spoolsw spool {on | off} ❒ Specify "on" to enable Job Spool, or "off" to disable it. ❖ Resetting Job spool setting msh> spoolsw clear job {on | off} • When the printer power is cut during job spooling, this determines whether to reprint the spooled job. ❖ Protocol configuration msh> spoolsw diprint {on | off} msh> spoolsw lpr {on | off} msh> spoolsw ipp {on | off} msh> spoolsw smb {on | off} msh> spoolsw ftp {on | off} • You can specify the settings for diprint, lpr, ipp, and smb. 240