Ricoh CL7200 Setup Guide - Page 357

Monitoring and Configuring the Printer Remote Maintenance by telnet ❒ Remote Maintenance should be password-protected so that access is allowed to administrators only. ❒ The password is the same as the one of Web Image Monitor administrator. When the password is changed using "mshell", other passwords change also. ❒ Some commands cannot be used depending on your printer. Using telnet Follow the procedure below to use telnet. ❒ Only one user at a time can log on to perform remote maintenance. A Use the IP address or the host name of the printer to start telnet. % telnetIP_address B Enter your user name and password. To use default account, enter "admin" as user name, and leave the password blank. C Enter a command. D Quit telnet. msh> logout The configuration message about saving the changes appears. E Enter "yes" to save the changes, and then press the {# Enter} key. If you do not want to save the changes, enter "no", and then press the {# Enter} key. To make further changes, enter "return" at the command line, and then press the {# Enter} key. ❒ If the message "Can not write NVRAM information" appears, the changes are not saved. Repeat the procedure above. ❒ When the changes are saved, the network interface board is reset automatically with that changes. ❒ When the network interface board resets, the print job in print process will be printed. However, print jobs in queue will be canceled. 217