Ricoh CL7200 Setup Guide - Page 358

Monitoring and Configuring the Printer access Use the "access" command to view and configure access control. You can also specify two or more access ranges. ❖ View settings msh> access ❖ Configuration msh> access range "start-address end-address" • represents a target number between 1 and 5. (Up to five access ranges can be registered and selected.) Example: to specify accessible IP addresses between 192.168.0.10 and 192.168.0.20: msh> access 1 range 192.168.0.10 192.168.0.20 ❖ Access control initialization msh> access flush • Use the "flush" command to restore the default settings so that all access ranges become "0.0.0.0". ❒ The access range restricts computers from use of the printer by IP address. If you do not need to restrict printing, make the setting "0.0.0.0". ❒ Valid ranges must be from lower (start address) to higher (end address). ❒ Up to five access ranges can be specified. The entry is invalid if the target number is omitted. ❒ You cannot access Web Image Monitor from a restricted IP address. appletalk Use the "appletalk" command to view and configure Appletalk parameters. ❖ View settings msh> appletalk • [2] means "active" and [0] means "inactive". • The default is [2]. ❖ Changing PAP timeout configuration msh> appletalk ptimeout value > 0 • Timeout value becomes effective. msh> appletalk ptimeout value = 0 218