Ricoh CL7200 Setup Guide - Page 377

Monitoring and Configuring the Printer IP address:0.0.0.0 Access type:read-write / trap off • If "-p" is added, you can view settings one by one. • To display the current community, specify its registration number. ❖ Display msh> snmp ? ❖ Community name configuration msh> snmp "number" name "community_name" • You can configure ten SNMP access settings numbered 1-10. • The printer cannot be accessed from SmartDeviceMonitor for Admin or SmartDeviceMonitor for Client if "public" is not registered in numbers 1-10. When changing the community name, use SmartDeviceMonitor for Admin and SNMP Setup Tool to correspond with printer settings. • The community name can be entered using up to 15 characters. ❖ Deleting community name msh> snmp "number" clear name ❖ Access type configuration msh> snmp "number" type "access_type" Access type no read write trap Type of access permission not accessible read only read and write user is notified of trap messages ❖ Protocol configuration msh> snmp {ip | ipx} {on | off} • Use the following command to set protocols "active" or "inactive": If you set a protocol "inactive", all access settings for that protocol are disabled. • Specify "ip" for TCP/IP, or "ipx" for IPX/SPX. • {on} means "active" and {off} means "inactive". • IEEE 1394 interface is available for TCP/IP only. ❖ Configuration of protocol for each registration number msh> snmp "number" active {ip | ipx} {on | off} • To change the protocol of access settings, use the following command. However, if you have disabled a protocol with the above command, activating it here has no effect. 237