Ricoh CL7200 Setup Guide - Page 579
Form Feed, Job Reset, feed table/Large Capacity Tray
UPC - 026649024115
View all Ricoh CL7200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 579 highlights
Troubleshooting Messages / Second messages Description Solution Change Setting Tray # / Paper Size: Paper Type: The paper size and type setting in the tray differs from that of actual paper size and type in the tray. #: tray number Load paper of the selected size in the tray, and then change the paper size setting with the control panel. Or, press the {Form Feed} key, and then select the tray using the control panel. Or, press the {Job Reset} key to cancel the print job. Check Toner Crtg XXX/XXX The indicated toner cartridge is not set correctly. XXX: Yellow/Magenta/Cyan/Black Set the indicated toner cartridge(s) correctly. See p.40 "Replacing the Toner Cartridge". Close Front Cover The front cover is open. Close the front cover for the printer. Close Right Cover The right cover is open. Close the right cover. Close Duplex Unit Cover The cover for the duplex unit is Close the cover for the duplex unit. open. Close Finisher Front Cover The front cover for the finisher Close the front cover for the finisher. is open. Close Finisher Upper Cover The finisher upper cover is open. The paper entrance cover for the finisher is open. Close the upper cover for the finisher. Close the upper entrance cover for the finisher. Close Lower Right Cover The right cover for the paper Close the right cover for the paper feed table/Large Capacity Tray feed table/Large Capacity Tray. is open. Close Upper Left Cover The upper left cover (the cover Close the upper left cover. for the fusing unit) is open. Close Upper Right Cover The upper right cover (the cov- Close the upper right cover. er for the toner cartridge) is open. DHCP assigned Cannot change An attempt to change the IP ad- Make the change after setting DHCP dress, subnet mask or gateway to [Off]. address was made while DHCP was set to [On]. 98