Ricoh CL7200 Setup Guide - Page 406

Monitoring and Configuring the Printer Message Problem and solutions phy release file open failed. Replacing the network interface board is required. Contact your sales or service representative. Print queue cannot be serviced by printer 0, (In the print server mode) The print queue cannot be established. Make sure that print queue exists on the specified file server. Print server has no printer. (In the print server mode) The printer is not assigned to the print server. Using NWadmin, assign the printer, and then restart it. print sessions full No more print jobs can be accepted. Printer has no queue (In the print server mode) The print queue is not assigned to the printer. Using NWadmin, assign the print queue to the printer, and then restart it. pserver start. (NetWare) (In the print server mode) The NetWare service has started. Required file server () not The required file server is not found. found restarted. The lpd service has started. sap enable, saptype=, sapname= The SAP function has started. The SAP packet is issued to advertise the service on the SAP table on the NetWare server. session already defined. The requested community name is not defined. session_ipx not defined. The requested community name is not defined. Set context to An NDS context name has been set. shutdown signal received. network service re- The network service is rebooting. booting... smbd started. (NetBIOS) smbd (Aerver Message Block Daemon) has started. SMTPC: failed to get smtp server ip-address. The SMTP server IP address could not be obtained. This could be because: • The specified DNS server could not be found. • No connection to the network has been established. • The specified DNS server could not be found. • An incorrect DNS server is specified. • The specified SMTP server IP address could not be found in the DNS server. 266