Ricoh CL7200 Setup Guide - Page 384

Monitoring and Configuring the Printer Parameter key [ key value ] val [1|2|3|4] keyphrase [ phrase ] val [1|2|3|4] encval [1|2|3|4] auth [open|shared] Value configured You can specify the WEP key when entering in hexadecimal. With a 64-bit WEP, you can use 10 digit hexadecimals. With a 128-bit WEP, you can use 26 digit hexadecimals. Up to four WEP keys can be registered. Specify the number to be registered with "val". When a WEP is specified by key, the WEP specified by key phrase is overwritten. To use this function, set the same key number and WEP key for all ports that transmit data to each other. You can omit the numbers with "val". The key number is set to 1 when making these omissions. You can specify the WEP key when entering in ASCII. With a 64-bit WEP, you can use 10 digit hexadecimals. With a 128-bit WEP, you can use 26 digit hexadecimals. Up to four WEP keys can be registered. Specify the number to be registered with "val". When a WEP is specified by key phrase, the WEP specified by key is overwritten. To use this function, set the same key number and WEP key for all ports that transmit data to each other. You can omit the numbers with "val". The key number is set to 1 when making these omissions. You can specify which of the four WEP keys is used for packet encoding. "1" is set if a number is not specified. You can set an authorization mode when using WEP. The specified value and authorized mode are as follows: open: open system authorized (default) shared: shared key authorized rate 244