Yamaha CS6R Owner's Manual - Page 85

Voice Mode s Src (Source) Set the Controller used to control the function chosen in Dest. The following nine controllers are available. t Settings: PB (Pitch Bend Wheel), MW (Modulation Wheel), AT (Aftertouch), FC (Foot Controller), FS (Foot Switch), RB (Ribbon Controller), BC (Breath Controller), KN1/2 (Knobs 1/2) s Dest (Destination) Set the parameter to be controlled by the Control Set in Src. t Settings: (see the Controls List of the separate Data List) s ElemSw (Element Switch) Select whether the Controller will affect each individual Element. Move the cursor (blinking) using Knob [1] and use the [DATA] knob or the [INC/YES] and [DEC/NO] keys to enable/disable the Elements which the Controller will affect. Affected Elements are shown by number. t Settings: Elements 1 to 4 enabled ("1" to "4" displayed) or disabled ("-" displayed) This is disabled if the Dest parameter is set to 00 to 33. s Depth Set the amount by which the parameter selected in Dest can be controlled. t Settings: -64 ~ 0 ~ +63 Example of Control Set Assignment Using Control Sets 1 to 6, you can assign individual Src (Source) controllers to multiple Dest (Destination) parameters, or multiple Src controllers to individual Dest parameters. Ex.1:Use a single Src controller to control multiple Dest parameters. SET1 Src MW (Modulation Wheel) SET2 Src MW (Modulation Wheel) Dest PAN Dest LFO Speed Use the Modulation Wheel to change both the Pan and LFO speed parameters simultaneously. Common LFO (Low Frequency Oscillator) There are various settings for the LFO. The LFO is used to generate low frequency signals and can be used to create vibrato, wah, tremolo and other effects when applied to pitch/filter/amplitude/etc. parameters. For example, variations can be simultaneously applied to both pitch and filter parameters, and to parameters specific to individual Elements. The following four settings are available. LFO Wave LFO Fade LFO Dest1 (LFO Destination 1) LFO Dest2 (LFO Destination 2) LFO Wave LFOíWave) Wave^ Speed KeyReset Phase C 1234 trpzd 63 on 270 s Wave Select the LFO Wave. Depending on the Wave selected, you can create different kinds of modulated sounds. The following 12 LFO waveforms are available. t Settings: tri, tri+, saw up, saw dw, squ1/4, squ1/3, squ, squ2/3, squ3/4, trpzd, S/H 1, S/H 2 tri saw up saw dw Ex.2:Use multiple Src controllers to control a single Dest parameter. SET1 Src KN1 (Assignable Knob 1) SET2 Src KN2 (Assignable Knob 2) Dest PAN Dest PAN Use either Assignable Knob [1] or [2] to change the pan parameter squ Details about Control Set Assignments are given in the Basics Section of this manual (Page 49). 85