Yamaha CS6R Owner's Manual - Page 99

Voice Mode s Level (Release Level) This shows the Release Level. (Fixed at zero.) Amplitude Envelope Generator Settings There are four Time settings (controlling the speed of changes in output level) and five Level settings (controlling the output level). The output level changes from the Initial Level to the Attack Level (127) within the Attack Time. It then changes in accordance with the Decay 1/2 Time and the Decay 1 Level, and settles at the Sustain Level. When the note is released, the output level falls to the Release Level (zero) within the Release Time. Velocity Sensitivity and other parameters can also be set if required. Level Attack Decay1 Sustain Release Level Level Level Key off Level Init Level 0 Attack Decay1 Decay2 Time Time Time Time Release Time AMP KeyFlw (AMP Key Follow) You can set Amplitude Key Follow parameters for each Element. This parameter controls the AEG behavior according to the positions of notes on the keyboard. The availability of the Amplitude Key Follow parameter depends on the Break Point and Offset settings in the AEG Scale screen. AMPíKeyFlw)Level-Center EGTime--Center EL1234 +200% (C 3) +63 C 3 s Center (Center Key) This shows that the basic Level is at note C3. At this note, the output level remains unchanged. For other notes, the output levels vary according to the Level settings. The Center setting cannot be changed. Speed of AEG + level change Large Small Lower range Center(Basic Pitch) Higher range s EGTime The EGTime parameter controls the AEG Times for each Element according to the positions of the notes on the keyboard. The Center parameter is used as the basic amplitude for this parameter. A positive setting will cause the amplitude of lower notes to change slower and that of higher notes to change faster. Negative values will have the opposite effect. t Settings: -64 ~ 0 ~ +63 s Center (Center Key) Set the basic pitch used by the EGTime parameter. When the Center note is played, the AEG behaves according to its actual settings. The amplitude change characteristics for other notes will vary in proportion to the EGTime settings. t Settings: C-2 ~ G8 You can also set this parameter by pressing the respective note on the keyboard while holding down the [SHIFT] key. Positive value Speed of AEG + level change s Level Set the Amplitude Key Follow ratio (the amount by which the output level varies according to note position) for each Element. A Center setting of C3 is used as the basic setting. A positive setting will lower the output level for lower notes and raise it for higher notes. A negative setting will have the opposite effect. t Settings: -200% ~ 0 ~ +200% Lower range Center(Basic Pitch) Higher range Negative value + Speed of AEG level change Lower range Center(Basic Pitch) Higher range 99