Yamaha CS6R Owner's Manual - Page 98

Voice Mode Element Amplitude You can set Amplitude parameters to affect the output level of each Element. The following seven screens are available. AEG VelSens (AEG Velocity Sensitivity) AEG Time AEG Level AEG Release AMP KeyFlw (AMP Key Follow) AMP Scale (AMP Scale Break Point) AMP Scale (AMP Scale Offset) AEG VelSens (AEG Velocity Sensitivity) You can set the sensitivity of the Amplitude Envelope Generator (AEG) to note velocity. AEGíVelSens) EL1234 Level +7 Time-Segment +63 attack s Attack (Attack Time) Set the Attack Time. t Settings: 0 ~ 127 s Decay1 (Decay 1 Time) Set the Decay 1 Time. t Settings: 0 ~ 127 s Decay2 (Decay 2 Time) Set the Decay 2 Time. t Settings: 0 ~ 127 AEG Level You can set various Level parameters for the Amplitude Envelope Generator (AEG). Combined with the AEG Time and AEG Release settings, these can be used control the change in output level from the moment a note is pressed on the keyboard to the moment it is released. You can set different values for each Element. s Level Set the sensitivity of the AEG's Level (its effectiveness) to note velocity. A positive setting will cause larger output level changes for notes played harder and smaller changes for notes played more softly. A negative setting will have the opposite effect. t Settings: -64 ~ 0 ~+63 s Time-Segment Set the velocity sensitivity of the AEG's Time parameters. Use Knob [2] to select the Segment, then use Knob [1] to set its Time parameter. Positive Time settings will play back the specified Segment faster and negative values will play it back slower. t Settings (Time): -64 ~ 0 ~ +63 t Settings (Segment): attack: Affects the Hold Time/Attack Time/Decay 1 Time all: Affects all AEG Time parameters AEG Time You can set various Time parameters for the Amplitude Envelope Generator (AEG). Combined with the AEG Level and AEG Release settings, these can be used control the change in output level from the moment a note is pressed on the keyboard to the moment it is released. You can set different values for each Element. AEGíTime) EL1234 Attack Decay1 Decay2 127 127 127 AEGíLevel) Init Attack Decay1 Sustain EL1234 127 (127) 127 0 s Init (Initial Level) Set the Initial Level. (The Level when a key is pressed.) t Settings: 0 ~ 127 s Attack (Attack Level) This shows the Attack Level. (Fixed at 127.) s Decay1 (Decay 1 Level) Set the Decay 1 Level. t Settings: 0 ~ 127 s Sustain (Sustain Level) Set the Sustain Level. t Settings: 0 ~ 127 AEG Release You can set Release Time and Release Level parameters for the Amplitude Envelope Generator (AEG). Combined with the AEG Time and AEG Level settings, these can be used control the change in output level from the moment a note is released. You can set different values for each Element. AEGíRelease) EL1234 Time Level 127 (0) s Time (Release Time) Set the Release Time. t Settings: 0 ~ 127 98