Computer Associates ARB6002700WF0. ..... Administration Guide - Page 82

Global Options Pre/Post Options These options allow you to run a command on your machine before or after the job is executed. For example, you may want to use the Pre option to stop the application that owns the data you are about to back up, and then use the Post option to start it again. Note: Commands with executables on remote systems are not supported. BrightStor ARCserve Backup provides the pre and post options described in the next few sections. Run Command Before Job Enter the path to and name of the file to be executed on the machine before the job takes off. ■ On Exit Code- BrightStor ARCserve Backup detects exit codes of other programs. You can specify the following options for a particular exit code: - Run Job Immediately-The job runs immediately if the appropriate code is selected. - Skip Job-The job does not run if the appropriate exit code is detected. - Skip Post Application-Skip any commands specified to run after the job if the appropriate code is detected. ■ Delay in Minutes-Specify the delay in which BrightStor ARCserve Backup waits before running a job when the appropriate exit code is detected. Run Command After Job Enter the path and name of the file to be executed on the machine after the job is completed. Do not run Command if Specify for a command not to run if BrightStor ARCserve Backup detects that a job fails, a job is incomplete, or a job is complete. Note: This option is not available when you are using BrightStor ARCserve Backup to manage a UNIX or Linux based server. 3-20 Administrator Guide