Dell PowerConnect J-8216 Hardware Guide - Page 109

Chapter 7: Planning Power Requirements Table 43: Estimated Values for Factors Causing Link Loss (continued) Link-Loss Factor Estimated Link-Loss Value Sample (LL) Calculation Values Connector 0.5 dBm This example assumes 5 connectors. Loss for 5 connectors: 5(0.5 dBm) = 2.5 dBm Splice 0.5 dBm This example assumes 2 splices. Loss for two splices: 2(0.5 dBm) = 1dBm Fiber attenuation • Multimode-1 dBm/km • Single mode-0.5 dBm/km Clock Recovery Module (CRM) 1 dBm This example assumes the link is 2 km long. Fiber attenuation for 2 km: • 2 km(1.0 dBm/km) = 2 dBm • 2 km( 0.5 dBm/km) = 1 dBm 1 dBm NOTE: For information about the actual amount of signal loss caused by equipment and other factors, see your vendor documentation for that equipment. 2. Calculate the (P ) by subtracting (LL) from (P ): M B P - LL = P B M 13 dBm - 0.5 dBm [HOL] - 5 (0.5 dBm) - 2 (0.5 dBm) - 2 km (1.0 dBm/km) - 1 dB [CRM] = P M 13 dBm - 0.5 dBm - 2.5 dBm - 1 dBm - 2 dBm - 1 dBm = P M P = 6 dBm M The calculated power margin is greater than zero, indicating that the link has sufficient power for transmission. Also, the power margin value does not exceed the maximum receiver input power. Refer to the specification for your receiver to find the maximum receiver input power. Related • Calculating the J-EX8200 Switch Fiber-Optic Cable Power Budget on page 91 Documentation • Optical Interface Support in J-EX8200 Switches on page 51 • Understanding J-EX8200 Switch Fiber-Optic Cable Signal Loss, Attenuation, and Dispersion on page 78 93