Dell PowerConnect J-8216 Hardware Guide - Page 160
Connecting and Configuring a J-EX Series Switch (CLI Procedure)
View all Dell PowerConnect J-8216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 160 highlights
Dell PowerConnect J-Series J-EX8216 Ethernet Switch Hardware Guide reset-chassis-lcd-menu; } } } protocols { igmp-snooping { vlan all; } lldp { interface all; } rstp; } ethernet-switching-options { storm-control { interface all; } } Related • Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 144 Documentation • Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 146 • For information about J-EX Series switch configuration files and interfaces and instructions for reverting to the factory default configuration, see the Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS at http://www.support.dell.com/manuals. • J-EX8216 Switch Hardware Overview on page 3 Connecting and Configuring a J-EX Series Switch (CLI Procedure) There are two ways to connect and configure a J-EX Series switch: one method is through the console using the CLI and the other is using the J-Web interface. This topic describes the CLI procedure. NOTE: To run the ezsetup script, the switch must have the factory default configuration as the active configuration. If you have configured anything on the switch and want to run ezsetup, revert to the factory default configuration. See Reverting to the Default Factory Configuration for the J-EX Series Switch. Before you begin connecting and configuring a J-EX Series switch through the console using the CLI: • Set the following parameter values in the console server or PC: • Baud Rate-9600 • Flow Control-None • Data-8 • Parity-None 144