Dell PowerConnect J-8216 Hardware Guide - Page 159
Performing Initial Configuration, J-EX8200 Switch Default Configuration
View all Dell PowerConnect J-8216 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
CHAPTER 11 Performing Initial Configuration • J-EX8200 Switch Default Configuration on page 143 • Connecting and Configuring a J-EX Series Switch (CLI Procedure) on page 144 • Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 146 J-EX8200 Switch Default Configuration Each J-EX8200 switch is programmed with a factory default configuration that contains the values set for each configuration parameter when a switch is shipped. The default configuration file sets values for system parameters such as the ARP aging timer, the system log, and file messages, while also enabling the LLDP protocol, the RSTP protocol, IGMP snooping, and storm control. When you commit changes to the configuration, a new configuration file is created that becomes the active configuration. You can always revert to the factory default configuration. For instructions for reverting to the factory configuration, see the Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS at http://www.support.dell.com/manuals. This topic shows the factory default configuration file of a J-EX8200 switch: system { arp { aging-timer 5 } } syslog { user * { any emergency; } file messages { any notice; authorization info; } file interactive-commands { interactive-commands any; } } commit { factory-settings { 143