Dell PowerConnect J-8216 Hardware Guide - Page 66

Dell PowerConnect J-Series J-EX8216 Ethernet Switch Hardware Guide NOTE: If your laptop or PC does not have a DB-9 male connector pin and you want to connect your laptop or PC directly to a J-EX Series switch, use a combination of the RJ-45 to DB-9 female adapter supplied with the switch and a USB to DB-9 male adapter. You must provide the USB to DB-9 male adapter. Table 26: J-EX Series Switches Console Port Connector Pinout Information Pin Signal Description 1 RTS Output Request to send 2 DTR Output Data terminal ready 3 TxD Output Transmit data 4 Signal Ground Signal ground 5 Signal Ground Signal ground 6 RxD Input Receive data 7 CD Input Data carrier detect 8 CTS Input Clear to send Related • See Routing Engine (RE) Module in a J-EX8216 Switch on page 26 for port location. Documentation • Connecting a J-EX Series Switch to a Management Console on page 136 Management Port Connector Pinout Information for a J-EX8200 Switch The management port on a J-EX8200 switch uses an RJ-45 connector to connect to a management device for out-of-band management. The port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T connection. Two LEDs on the port indicate link/activity on the port and the administrative status of the port. See "Management Port LEDs in J-EX8200 Switches" on page 29. Table 27 on page 50 provides the pinout information of the RJ-45 connector. An RJ-45 cable, with a connector attached, is supplied with the switch. Table 27: Management Port Connector Pinout Information for J-EX8200 Switches Pin Signal Description 1 TRP1+ Transmit/receive data pair 1 2 TRP1- Transmit/receive data pair 1 50