Dell PowerConnect J-8216 Hardware Guide - Page 65

CHAPTER 3 Component Specifications • USB Port Specifications for a J-EX Series Switch on page 49 • Console Port Connector Pinout Information for a J-EX Series Switch on page 49 • Management Port Connector Pinout Information for a J-EX8200 Switch on page 50 • Optical Interface Support in J-EX8200 Switches on page 51 • Grounding Cable and Lug Specifications for J-EX8200 Switches on page 59 USB Port Specifications for a J-EX Series Switch The USB port on a J-EX Series switch accepts a USB flash drive. All USB flash drives used on the switches must have the following features: • USB 2.0 or later. • Formatted with a FAT or MS-DOS file system. CAUTION: The use of any USB memory product not supported for J-EX Series switches could expose your switch to unpredictable behavior. Dell can provide only limited support for issues related to unsupported hardware. We strongly recommend that you use only supported USB flash drives. Related Documentation • See Routing Engine (RE) Module in a J-EX8216 Switch on page 26 for port location. • For information about booting the switch from a software package installed on a USB flash drive, see the the Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS at http://www.support.dell.com/manuals. Console Port Connector Pinout Information for a J-EX Series Switch The console port on a J-EX Series switch is an RS-232 serial interface that uses an RJ-45 connector to connect to a console management device. The default baud rate for the console port is 9600 baud. Table 26 on page 50 provides the pinout information for the RJ-45 console connector. An RJ-45 cable and an RJ-45 to DB-9 serial port adapter are supplied with the switch. 49