Dell PowerEdge SC440 Hardware Owner's Manual - Page 75
Removing the I/O Panel Assembly
View all Dell PowerEdge SC440 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Removing the I/O Panel Assembly 1 Turn off the system and attached peripherals, and disconnect the system from the electrical outlet. 2 Open the system. See "Opening the System" on page 41. 3 Remove the heat sink and shroud assembly. See "Removing the Processor" on page 62. Do not remove the processor, however. 4 Remove the processor cooling fan. See "Removing the Cooling Fans" on page 65. 5 Remove the front bezel. See "Removing the Bezel" on page 73. NOTICE: Carefully note the routing of each cable before you disconnect it, so that you are sure to re-route cables correctly. 6 Disconnect the I/O panel ribbon cable from the I/O panel connector by pulling the yellow cable loop. 7 Remove the mounting screw holding the I/O panel assembly to the front chassis. See Figure 3-22. 8 Lift the I/O panel assembly out of the system. Figure 3-22. Removing and Installing the I/O Panel Assembly 1 2 3 4 1 I/O panel assembly 4 screw on the I/O panel 2 I/O panel ribbon cable 3 holding tab on the chassis Installing System Components 75