Epson PhotoPC 850Z User Manual - Page 193

LCD screeen messages (Continued) Message OK to erase printing settings? Batteries are low. Use AC adapter. Error. Settings reset to default. Insert a Memory Card in the camera. Printing canceled. Printing canceled. Reset printer and camera. Description You are about to erase the current print settings. Press the button next to YES (the bottom button) to erase the settings, or press the button next to NO (the top button) to save the settings and return to the previous menu. Battery power is almost out. If you have the optional AC adapter, connect it to continue. Otherwise, replace the batteries with batteries that have been fully charged. An unknown error occurred and your settings were returned to their defaults. Press the bottom button to return to the main menu and enter your print settings again. No memory card is installed in the camera, or the memory card is not fully inserted into its slot. Insert a memory card as described on page 1-8. You held down the MENU button to cancel printing. The message disappears after three seconds. A printing error occurred. The message disappears after three seconds. Turn off the camera and printer, then turn them on and try printing again. Status display panel messages Message Description E51: Another interface is active The printer is receiving a print job from another source (through a different interface). When that print job is finished, the printer begins printing from Direct Print automatically. E55: No ink Printing has stopped because the printer ran out of ink. Replace the ink cartridges and restart printing from the beginning. See your printer manual for instructions on replacing ink cartridges. E56: No paper or paper jam Make sure paper is loaded in the printer, then press the printer's E Load/Eject button to begin printing. If paper is jammed in the printer, follow the instructions in your printer manual to clear the jam. Then restart printing from the beginning. 14-18 Printing Directly From the Camera