HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 109

Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands dot1x timeout dot1x timeout Use the dot1x timeout interface configuration command to set IEEE 802.1x timers. Use the no form of this command to return to the default setting. dot1x timeout {quiet-period seconds | ratelimit-period seconds | reauth-period {seconds | server} | server-timeout seconds | supp-timeout seconds | tx-period seconds} no dot1x timeout {quiet-period | reauth-period | server-timeout | supp-timeout | tx-period} Syntax Description quiet-period seconds Number of seconds that the switch remains in the quiet state following a failed authentication exchange with the client. The range is 1 to 65535. ratelimit-period seconds Number of seconds that the switch ignores Extensible Authentication Protocol over LAN (EAPOL) packets from clients that have been successfully authenticated during this duration. The range is 1 to 65535. reauth-period {seconds | Set the number of seconds between re-authentication attempts. server} The keywords have these meanings: • seconds-Sets the number of seconds from 1 to 65535; the default is 3600 seconds. • server-Sets the number of seconds as the value of the Session-Timeout RADIUS attribute (Attribute[27]). server-timeout seconds Number of seconds that the switch waits for the retransmission of packets by the switch to the authentication server. The range is 30 to 65535. supp-timeout seconds Number of seconds that the switch waits for the retransmission of packets by the switch to the IEEE 802.1x client. The range is 30 to 65535. tx-period seconds Number of seconds that the switch waits for a response to an EAP-request/identity frame from the client before retransmitting the request. The range is 5 to 65535. Defaults These are the default settings: reauth-period is 3600 seconds. quiet-period is 60 seconds. tx-period is 5 seconds. supp-timeout is 30 seconds. server-timeout is 30 seconds. rate-limit is 1 second. Command Modes Interface configuration OL-8916-01 Cisco Catalyst Blade Switch 3020 for HP Command Reference 2-81