HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 341
show interfaces accounting, show interfaces capabilities
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 341 highlights
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands show interfaces Queueing strategy: fifo Output queue :0/40 (size/max) 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 2 packets input, 1040 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 0 watchdog, 0 multicast, 0 pause input 0 input packets with dribble condition detected 4 packets output, 1040 bytes, 0 underruns 0 output errors, 0 collisions, 3 interface resets 0 babbles, 0 late collision, 0 deferred 0 lost carrier, 0 no carrier, 0 PAUSE output 0 output buffer failures, 0 output buffers swapped out This is an example of output from the show interfaces accounting command. Switch# show interfaces accounting Vlan1 Protocol Pkts In Chars In IP 1094395 131900022 Spanning Tree 283896 17033760 ARP 63738 3825680 Interface Vlan2 is disabled Vlan7 Protocol Pkts In Chars In No traffic sent or received on this interface. Vlan31 Protocol Pkts In Chars In No traffic sent or received on this interface. Pkts Out 559555 42 231 Chars Out 84077157 2520 13860 Pkts Out Chars Out Pkts Out Chars Out GigabitEthernet0/21 Protocol Pkts In Chars In No traffic sent or received on this interface. GigabitEthernet0/22 Protocol Pkts In Chars In No traffic sent or received on this interface. Pkts Out Chars Out Pkts Out Chars Out This is an example of output from the show interfaces capabilities command for an interface. Switch# show interfaces gigabitethernet0/21 capabilities GigabitEthernet0/2 Model: WS-CBS3020-HPQ Type: 10/100/1000BaseTX Speed: 10,100,1000,auto Duplex: half,full,auto Trunk encap. type: 802.1Q,ISL Trunk mode: on,off,desirable,nonegotiate Channel: yes Broadcast suppression: percentage(0-100) Flowcontrol: rx-(off,on,desired),tx-(none) Fast Start: yes QoS scheduling: rx-(not configurable on per port basis),tx-(4q2t) CoS rewrite: yes ToS rewrite: yes UDLD: yes Inline power: no SPAN: source/destination PortSecure: yes Dot1x: yes OL-8916-01 Cisco Catalyst Blade Switch 3020 for HP Command Reference 2-315