HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 95
dot1x default, show dot1x, interface
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands dot1x default dot1x default Use the dot1x default interface configuration command to reset the IEEE 802.1x parameters to their default values. dot1x default Syntax Description This command has no arguments or keywords. Defaults These are the default values: • The per-port IEEE 802.1x protocol enable state is disabled (force-authorized). • The number of seconds between re-authentication attempts is 3600 seconds. • The periodic re-authentication is disabled. • The quiet period is 60 seconds. • The retransmission time is 30 seconds. • The maximum retransmission number is 2 times. • The host mode is single host. • The client timeout period is 30 seconds. • The authentication server timeout period is 30 seconds. Command Modes Interface configuration Command History Release 12.2(25)SEF Modification This command was introduced. Examples This example shows how to reset the IEEE 802.1x parameters on a port: Switch(config-if)# dot1x default You can verify your settings by entering the show dot1x [interface interface-id] privileged EXEC command. Related Commands Command Description show dot1x [interface interface-id] Displays IEEE 802.1x status for the specified port. OL-8916-01 Cisco Catalyst Blade Switch 3020 for HP Command Reference 2-67