HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 114
errdisable detect cause, errdisable recovery
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 114 highlights
errdisable detect cause Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands errdisable detect cause Use the errdisable detect cause global configuration command to enable error-disabled detection for a specific cause or all causes. Use the no form of this command to disable the error-disabled detection feature. errdisable detect cause {all | dhcp-rate-limit | dtp-flap | gbic-invalid | link-flap | loopback | pagp-flap} no errdisable detect cause {all | dhcp-rate-limit | dtp-flap | gbic-invalid | link-flap | pagp-flap} Syntax Description all dhcp-rate-limit dtp-flap gbic-invalid link-flap loopback pagp-flap Enable error detection for all error-disabled causes. Enable error detection for DHCP snooping. Enable error detection for the Dynamic Trunking Protocol (DTP) flapping. Enable error detection for an invalid Gigabit Interface Converter (GBIC) module. Note This error refers to an invalid small form-factor pluggable (SFP) module. Enable error detection for link-state flapping. Enable error detection for detected loopbacks. Enable error detection for the Port Aggregation Protocol (PAgP) flap error-disabled cause. Command Default Detection is enabled for all causes. Command Modes Global configuration Command History Release 12.2(25)SEF Modification This command was introduced. Usage Guidelines A cause (all, dhcp-rate-limit, and so forth) is the reason why the error-disabled state occurred. When a cause is detected on an interface, the interface is placed in an error-disabled state, an operational state that is similar to a link-down state. If you set a recovery mechanism for the cause by entering the errdisable recovery global configuration command for the cause, the interface is brought out of the error-disabled state and allowed to retry the operation when all causes have timed out. If you do not set a recovery mechanism, you must enter the shutdown and then the no shutdown commands to manually recover an interface from the error-disabled state. 2-86 Cisco Catalyst Blade Switch 3020 for HP Command Reference OL-8916-01