HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 510
srr-queue bandwidth limit
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 510 highlights
srr-queue bandwidth limit Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands srr-queue bandwidth limit Use the srr-queue bandwidth limit interface configuration command to limit the maximum output on a port. Use the no form of this command to return to the default setting. srr-queue bandwidth limit weight1 no srr-queue bandwidth limit Syntax Description weight1 Percentage of the port speed to which the port should be limited. The range is 10 to 90. Defaults The port is not rate limited and is set to 100 percent. Command Modes Interface configuration Command History Release 12.2(25)SEF Modification This command was introduced. Usage Guidelines If you configure this command to 80 percent, the port is idle 20 percent of the time. The line rate drops to 80 percent of the connected speed. These values are not exact because the hardware adjusts the line rate in increments of six. Note The egress queue default settings are suitable for most situations. You should change them only when you have a thorough understanding of the egress queues and if these settings do not meet your quality of service (QoS) solution. Examples This example shows how to limit a port to 800 Mbps: Switch(config)# interface gigabitethernet0/1 Switch(config-if)# srr-queue bandwidth limit 80 You can verify your settings by entering the show mls qos interface [interface-id] queueing privileged EXEC command. 2-482 Cisco Catalyst Blade Switch for HP Command Reference OL-8916-01