HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 503
spanning-tree uplinkfast
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 503 highlights
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands spanning-tree uplinkfast spanning-tree uplinkfast Use the spanning-tree uplinkfast global configuration command to accelerate the choice of a new root port when a link or switch fails or when the spanning tree reconfigures itself. Use the no form of this command to return to the default setting. spanning-tree uplinkfast [max-update-rate pkts-per-second] no spanning-tree uplinkfast [max-update-rate] Syntax Description max-update-rate pkts-per-second (Optional) The number of packets per second at which update packets are sent. The range is 0 to 32000. Defaults UplinkFast is disabled. The update rate is 150 packets per second. Command Modes Global configuration Command History Release 12.2(25)SEF Modification This command was introduced. Usage Guidelines Use this command only on access switches. You can configure the UplinkFast feature for rapid PVST+ or for multiple spanning-tree (MST) mode, but the feature remains disabled (inactive) until you change the spanning-tree mode to PVST+. When you enable UplinkFast, it is enabled for the entire switch and cannot be enabled for individual VLANs. When UplinkFast is enabled, the switch priority of all VLANs is set to 49152. If you change the path cost to a value less than 3000 and you enable UplinkFast or UplinkFast is already enabled, the path cost of all interfaces and VLAN trunks is increased by 3000 (if you change the path cost to 3000 or above, the path cost is not altered). The changes to the switch priority and the path cost reduces the chance that a switch will become the root switch. When UplinkFast is disabled, the switch priorities of all VLANs and path costs of all interfaces are set to default values if you did not modify them from their defaults. When spanning tree detects that the root port has failed, UplinkFast immediately changes to an alternate root port, changing the new root port directly to forwarding state. During this time, a topology change notification is sent. OL-8916-01 Cisco Catalyst Blade Switch for HP Command Reference 2-475