HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 516

storm-control Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands storm-control Use the storm-control interface configuration command to enable broadcast, multicast, or unicast storm control and to set threshold levels on an interface. Use the no form of this command to return to the default setting. storm-control {{broadcast | multicast | unicast} level {level [level-low] | bps bps [bps-low] | pps pps [pps-low]}} | {action {shutdown | trap}} no storm-control {{broadcast | multicast | unicast} level} | {action {shutdown | trap}} Syntax Description broadcast multicast unicast level level [level-low] level bps bps [bps-low] Enable broadcast storm control on the interface. Enable multicast storm control on the interface. Enable unicast storm control on the interface. Specify the rising and falling suppression levels as a percentage of total bandwidth of the port. • level-Rising suppression level, up to two decimal places. The range is 0.00 to 100.00. Block the flooding of storm packets when the value specified for level is reached. • level-low-(Optional) Falling suppression level, up to two decimal places. The range is 0.00 to 100.00. This value must be less than or equal to the rising suppression value. If you do not configure a falling suppression level, it is set to the rising suppression level. Specify the rising and falling suppression levels as a rate in bits per second at which traffic is received on the port. • bps-Rising suppression level, up to 1 decimal place. The range is 0.0 to 10000000000.0. Block the flooding of storm packets when the value specified for bps is reached. • bps-low-(Optional) Falling suppression level, up to 1 decimal place. The range is 0.0 to 10000000000.0. This value must be equal to or less than the rising suppression value. You can use metric suffixes such as k, m, and g for large number thresholds. 2-488 Cisco Catalyst Blade Switch for HP Command Reference OL-8916-01