HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 58

channel-group Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands For a complete list of configuration guidelines, see the "Configuring EtherChannels" chapter in the software configuration guide for this release. Examples This example shows how to configure an EtherChannel. It assigns two static-access ports in VLAN 10 to channel 5 with the PAgP mode desirable: Switch# configure terminal Switch(config)# interface range gigabitethernet0/21 -22 Switch(config-if-range)# switchport mode access Switch(config-if-range)# switchport access vlan 10 Switch(config-if-range)# channel-group 5 mode desirable Switch(config-if-range)# end This example shows how to configure an EtherChannel. It assigns two static-access ports in VLAN 10 to channel 5 with the LACP mode active: Switch# configure terminal Switch(config)# interface range gigabitethernet0/21 -22 Switch(config-if-range)# switchport mode access Switch(config-if-range)# switchport access vlan 10 Switch(config-if-range)# channel-group 5 mode active Switch(config-if-range)# end You can verify your settings by entering the show running-config privileged EXEC command. Related Commands Command channel-protocol interface port-channel show etherchannel show lacp show pagp show running-config Description Restricts the protocol used on a port to manage channeling. Accesses or creates the port channel. Displays EtherChannel information for a channel. Displays LACP channel-group information. Displays PAgP channel-group information. Displays the current operating configuration. For syntax information, select Cisco IOS Configuration Fundamentals Command Reference, Release 12.2 > File Management Commands > Configuration File Management Commands. 2-30 Cisco Catalyst Blade Switch 3020 for HP Command Reference OL-8916-01