HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 176

logging file Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands Usage Guidelines The log file is stored in ASCII text format in an internal buffer on the switch. You can access logged system messages by using the switch command-line interface (CLI) or by saving them to a properly configured syslog server. If the switch fails, the log is lost unless you had previously saved it to flash memory by using the logging file flash:filename global configuration command. After saving the log to flash memory by using the logging file flash:filename global configuration command, you can use the more flash:filename privileged EXEC command to display its contents. The command rejects the minimum file size if it is greater than the maximum file size minus 1024; the minimum file size then becomes the maximum file size minus 1024. Specifying a level causes messages at that level and numerically lower levels to be displayed. Examples This example shows how to save informational log messages to a file in flash memory: Switch(config)# logging file flash:logfile informational You can verify your setting by entering the show running-config privileged EXEC command. Related Commands Command show running-config Description Displays the running configuration on the switch. For syntax information, select Cisco IOS Configuration Fundamentals Command Reference, Release 12.2 > File Management Commands > Configuration File Management Commands. 2-148 Cisco Catalyst Blade Switch 3020 for HP Command Reference OL-8916-01