HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 555
udld, Cisco Catalyst Blade Switch for HP Command Reference, OL-8916-01,
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 555 highlights
Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands udld udld Use the udld global configuration command to enable aggressive or normal mode in the UniDirectional Link Detection (UDLD) and to set the configurable message timer time. Use the no form of the command to disable aggressive or normal mode UDLD on all fiber-optic ports. udld {aggressive | enable | message time message-timer-interval} no udld {aggressive | enable | message} Syntax Description aggressive enable message time message-timer-interval Enable UDLD in aggressive mode on all fiber-optic interfaces. Enable UDLD in normal mode on all fiber-optic interfaces. Configure the period of time between UDLD probe messages on ports that are in the advertisement phase and are determined to be bidirectional. The range is 90 seconds. Defaults UDLD is disabled on all interfaces. The message timer is set at 60 seconds. Command Modes Global configuration Command History Release 12.2(25)SEF Modification This command was introduced. Usage Guidelines UDLD supports two modes of operation: normal (the default) and aggressive. In normal mode, UDLD detects unidirectional links due to misconnected interfaces on fiber-optic connections. In aggressive mode, UDLD also detects unidirectional links due to one-way traffic on fiber-optic and twisted-pair links and due to misconnected interfaces on fiber-optic links. For information about normal and aggressive modes, see the "Understanding UDLD" section in the software configuration guide for this release. If you change the message time between probe packets, you are making a trade-off between the detection speed and the CPU load. By decreasing the time, you can make the detection-response faster but increase the load on the CPU. This command affects fiber-optic interfaces only. Use the udld interface configuration command to enable UDLD on other interface types. You can use these commands to reset an interface shut down by UDLD: • The udld reset privileged EXEC command to reset all interfaces shut down by UDLD • The shutdown and no shutdown interface configuration commands • The no udld enable global configuration command followed by the udld {aggressive | enable} global configuration command to re-enable UDLD globally OL-8916-01 Cisco Catalyst Blade Switch for HP Command Reference 2-527