HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 411

Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands show pagp show pagp Use the show pagp user EXEC command to display Port Aggregation Protocol (PAgP) channel-group information. show pagp [channel-group-number] {counters | internal | neighbor} [ | {begin | exclude | include} expression]] Syntax Description channel-group-number counters internal neighbor | begin | exclude | include expression (Optional) Number of the channel group. The range is 1 to 48. Display traffic information. Display internal information. Display neighbor information. (Optional) Display begins with the line that matches the expression. (Optional) Display excludes lines that match the expression. (Optional) Display includes lines that match the specified expression. Expression in the output to use as a reference point. Command Modes User EXEC Command History Release 12.2(25)SEF Modification This command was introduced. Usage Guidelines You can enter any show pagp command to display the active channel-group information. To display the nonactive information, enter the show pagp command with a channel-group number. Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output do not appear, but the lines that contain Output are appear. Examples OL-8916-01 This is an example of output from the show pagp 1 counters command: Switch> show pagp 1 counters Information Flush Port Sent Recv Sent Recv Channel group: 1 Gi0/21 45 42 0 0 Gi0/22 45 41 0 0 This is an example of output from the show pagp 1 internal command: Switch> show pagp 1 internal Flags: S - Device is sending Slow hello. A - Device is in Auto mode. Timers: H - Hello timer is running. S - Switching timer is running. C - Device is in Consistent state. Q - Quit timer is running. I - Interface timer is running. Channel group 1 Cisco Catalyst Blade Switch 3020 for HP Command Reference 2-385