HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 172

link state group Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands Examples This example shows how to configure the interfaces as upstream in group 2: Switch# configure terminal Switch(config)# interface range gigabitethernet0/23 - 24 Switch(config-if)# link state group 2 upstream Switch(config-if)# end Note If the interfaces are part of an EtherChannel, you must specify the port channel name as part of the link state group, not the individual port members. This example shows how to create a link-state group using ports in an EtherChannel: Switch# configure terminal Switch(config)# link state track 1 Switch(config)# interface P01 Switch(config-if)# link state group 1 upstream Switch(config-if-range)# interface range gigabitethernet0/1, gigabitethernet0/3, gigabitethernet0/5 Switch(config-if)# link state group 1 downstream Switch(config-if)# end You can verify your settings by entering the show running-config privileged EXEC command. Related Commands Command link state track show link state group show running-config Description Enables a link-state group. Displays the link-state group information. Displays the current operating configuration. For syntax information, select Cisco IOS Configuration Fundamentals Command Reference for Release 12.2 > Cisco IOS File Management Commands > Configuration File Commands. 2-144 Cisco Catalyst Blade Switch 3020 for HP Command Reference OL-8916-01