HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 117

Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands errdisable recovery Note Though visible in the command-line help strings, the ilpower, storm-control, and unicast-flood keywords are not supported. Defaults Recovery is disabled for all causes. The default recovery interval is 300 seconds. Command Modes Global configuration Command History Release 12.2(25)SEF Modification This command was introduced. Usage Guidelines A cause (all, bpduguard, and so forth) is defined as the reason that the error-disabled state occurred. When a cause is detected on an interface, the interface is placed in the error-disabled state, an operational state similar to link-down state. If you do not enable the recovery for the cause, the interface stays in the error-disabled state until you enter the shutdown and the no shutdown interface configuration commands. If you enable the recovery for a cause, the interface is brought out of the error-disabled state and allowed to retry the operation again when all the causes have timed out. Otherwise, you must enter the shutdown and then the no shutdown commands to manually recover an interface from the error-disabled state. Examples This example shows how to enable the recovery timer for the BPDU guard error-disabled cause: Switch(config)# errdisable recovery cause bpduguard This example shows how to set the timer to 500 seconds: Switch(config)# errdisable recovery interval 500 You can verify your settings by entering the show errdisable recovery privileged EXEC command. Related Commands Command show errdisable recovery show interfaces status err-disabled Description Displays error-disabled recovery timer information. Displays interface status or a list of interfaces in error-disabled state. OL-8916-01 Cisco Catalyst Blade Switch 3020 for HP Command Reference 2-89