HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 532

switchport port-security Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands Command History Release 12.2(25)SEF Modification This command was introduced. Usage Guidelines A secure port has the following limitations: • A secure port can be an access port or a trunk port; it cannot be a dynamic access port. • A secure port cannot be a protected port. • A secure port cannot be a destination port for Switched Port Analyzer (SPAN). • A secure port cannot belong to a Gigabit EtherChannel port group. • You cannot configure static secure or sticky secure MAC addresses in the voice VLAN. • When you enable port security on an interface that is also configured with a voice VLAN, set the maximum allowed secure addresses on the port to two. When the port is connected to a Cisco IP phone, the IP phone requires one MAC address. The Cisco IP phone address is learned on the voice VLAN, but is not learned on the access VLAN. If you connect a single PC to the Cisco IP phone, no additional MAC addresses are required. If you connect more than one PC to the Cisco IP phone, you must configure enough secure addresses to allow one for each PC and one for the Cisco IP phone. • Voice VLAN is supported only on access ports and not on trunk ports. • When you enter a maximum secure address value for an interface, if the new value is greater than the previous value, the new value overrides the previously configured value. If the new value is less than the previous value and the number of configured secure addresses on the interface exceeds the new value, the command is rejected. • The switch does not support port security aging of sticky secure MAC addresses. A security violation occurs when the maximum number of secure MAC addresses are in the address table and a station whose MAC address is not in the address table attempts to access the interface or when a station whose MAC address is configured as a secure MAC address on another secure port attempts to access the interface. When a secure port is in the error-disabled state, you can bring it out of this state by entering the errdisable recovery cause psecure-violation global configuration command, or you can manually re-enable it by entering the shutdown and no shut down interface configuration commands. Setting a maximum number of addresses to one and configuring the MAC address of an attached device ensures that the device has the full bandwidth of the port. When you enter a maximum secure address value for an interface, this occurs: • If the new value is greater than the previous value, the new value overrides the previously configured value. • If the new value is less than the previous value and the number of configured secure addresses on the interface exceeds the new value, the command is rejected. 2-504 Cisco Catalyst Blade Switch for HP Command Reference OL-8916-01