HP Cisco Catalyst Blade Switch 3020 Cisco Catalyst Blade Switch 3020 for HP Co - Page 288
Cisco Catalyst Blade Switch 3020 for HP Command Reference, OL-8916-01, setup
View all HP Cisco Catalyst Blade Switch 3020 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 288 highlights
setup Chapter 2 Cisco Catalyst Blade Switch 3020 for HP Cisco IOS Commands Enter host name [Switch]:host-name The enable secret is a password used to protect access to privileged EXEC and configuration modes. This password, after entered, becomes encrypted in the configuration. Enter enable secret: enable-secret-password The enable password is used when you do not specify an enable secret password, with some older software versions, and some boot images. Enter enable password: enable-password The virtual terminal password is used to protect access to the router over a network interface. Enter virtual terminal password: terminal-password Configure SNMP Network Management? [no]: yes Community string [public]: Current interface summary Any interface listed with OK? value "NO" does not have a valid configuration Interface Vlan1 IP-Address OK? Method Status 172.20.135.202 YES NVRAM up Protocol up GigabitEthernet0/1 unassigned YES unset up up GigabitEthernet0/2 unassigned YES unset up down Port-channel1 unassigned YES unset up down Enter interface name used to connect to the management network from the above interface summary: vlan1 Configuring interface vlan1: Configure IP on this interface? [yes]: yes IP address for this interface: ip_address Subnet mask for this interface [255.0.0.0]: subnet_mask The following configuration command script was created: hostname host-name enable secret 5 $1$LiBw$0Xc1wyT.PXPkuhFwqyhVi0 enable password enable-password line vty 0 15 password terminal-password snmp-server community public ! no ip routing ! interface GigabitEthernet0/1 no ip address ! interface GigabitEthernet0/2 no ip address ! 2-262 Cisco Catalyst Blade Switch 3020 for HP Command Reference OL-8916-01