HP ProLiant DL170e HP ProLiant DL170e G6 Server Maintenance and Service Guide - Page 130
Removal and replacement procedures, Removing the GPU Card, Installing the Adapter Board on the Bracket
![]() |
View all HP ProLiant DL170e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
Figure 134 Removing the GPU Card To install the GPU adapter board on the 2U node: 1. Remove the 2U PCIe cage away from the system board tray as shown in Figure 81. 2. Remove the 2U upper sheet metal air baffle from the system board tray as shown in Figure 82. 3. Align the adapter board to the bracket by the two screw holes. 4. Install the adapter board on the bracket with two screws. Figure 135 Installing the Adapter Board on the Bracket 5. Install the GPU. There are two types of GPU: one is with single slot and the other is with double slots. The following installation process uses the single-slot GPU as an example: a. Loosen the thumbscrew that secures the card holder bracket to the 2U PCIe cage. b. Lift and route one end of the card holder bracket away from the 2U PCIe cage. c. Remove the other end of the card holder bracket away from the slot of the 2U PCIe cage. Removal and replacement procedures 130
![](/manual_guide/products/hewlettpackard-proliant-dl170e-hp-proliant-dl170e-g6-server-maintenance-service-guide-4b5be1d/130.png)