HP ProLiant DL170e HP ProLiant DL170e G6 Server Maintenance and Service Guide - Page 140
Removal and replacement procedures, Removing the System Board from 1U System Board Tray
View all HP ProLiant DL170e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
8. Remove all processors and memory modules. Refer to the sections of Processor and Memory for details. 9. Loosen the 6 screws that secure the system board to the 1U system board tray. 10. Slide the system board in the direction as shown in the figure below, and remove it out of the chassis. Figure 152 Removing the System Board from 1U System Board Tray To install the 1U system board: 1. Align the system board I/O connectors to their openings and route down the other side of the system board into place. The screw holes on the 1U system board tray should align with the system board. 2. Fasten the 6 screws that secure the system board to the 1U system board tray. Figure 153 Reinstalling the System Board to 1U System Board Tray 3. Install all removed cables to the system board. 4. Install the processors and memory modules. Refer to the sections of Processor and Memory for details. Removal and replacement procedures 140