HP ProLiant DL170e HP ProLiant DL170e G6 Server Maintenance and Service Guide - Page 152
To install the big C bus bar pair, Removal and replacement procedures
![]() |
View all HP ProLiant DL170e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 152 highlights
Figure 172 Removing the Midplane Assembly 5. Loosen the 2 screws that link the small C bus bar pair to the bottom midplane. 6. Remove the small C bus bar pair from the bottom midplane. Figure 173 Removing the Small C Pair To install the big C bus bar pair: 1. Align the big C bus bar pair to the 4 screw holes on the bottom power backplane. 2. From the bottom side of the bottom power backplane, install the 4 screws to secure the big C bus bar pair to the bottom power backplane. NOTE: Install the screws with strength of 10~30 in/lbs. You can use T10/T15 wrench or handtighten plus 1/4 turn. Removal and replacement procedures 152
![](/manual_guide/products/hewlettpackard-proliant-dl170e-hp-proliant-dl170e-g6-server-maintenance-service-guide-4b5be1d/152.png)
Removal and replacement procedures
152
Figure 172
Removing the Midplane Assembly
5.
Loosen the 2 screws that link the small C bus bar pair to the bottom midplane.
6.
Remove the small C bus bar pair from the bottom midplane.
Figure 173
Removing the Small C Pair
To install the big C bus bar pair:
1.
Align the big C bus bar pair to the 4 screw holes on the bottom power backplane.
2.
From the bottom side of the bottom power backplane, install the 4 screws to secure the big C
bus bar pair to the bottom power backplane.
NOTE:
Install the screws with strength of 10~30 in/lbs. You can use T10/T15 wrench or hand-
tighten plus 1/4 turn.