IBM 86884RX Maintenance Manual - Page 104
installation
View all IBM 86884RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
6. Install the adapter: a. If you are installing a full-length adapter, open the blue adapter guide by lifting the front edge, as shown in the illustration. b. Push the orange adapter-retention latch toward the rear of the server, and open the tab. c. Remove the expansion-slot cover. d. Carefully grasp the adapter by its top edge or upper corners, and align it with the connector on the PCI-X board. Note: Some long adapters have extension handles or brackets. Before installing a long adapter, you must remove the extension handle or bracket. e. Press the adapter firmly into the adapter connector. Attention: When you install an adapter, be sure the adapter is correctly seated in the connector. Improperly seated adapters might cause damage to the PCI-X board or to the adapter. f. Push down on the blue adapter guide to keep the adapter steady. g. Close the tab; then, push down on the blue adapter-retention latch until it clicks into place, securing the adapter. Adapter guide PCI-X divider Adapter Tab retention latch Attention LED Power LED NOTE: FOR PROPER FRONT OF BOX AIRFLOW, NOTE: FOR PROPER AIRFLOW, FRONT OF BOX REPLACE FAN WITHIN 2 MINUTES REPLACE FAN WITHIN 2 MINUTES 7. Connect the internal cables to the adapter. 8. If you disabled the slot in step 2 on page 93, enable the slot. 9. If you have other options to install or remove, do so now. Otherwise, go to "Completing the installation" on page 111. 94 IBM xSeries 450 Type 8688: Hardware Maintenance Manual and Troubleshooting Guide