IBM 86884RX Maintenance Manual - Page 151
assembly, mechanism
View all IBM 86884RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
9. Place the new locking slides in the processor-board assembly. 10. Place the new memory-board retaining latches and the retention spring, and secure them with the screws that you removed in step 7 on page 140. Latch handle Retention spring Screw Sliding lock Note: When you install or remove the processor-board assembly, the server configuration information changes. Therefore, you must use the Configuration/Setup Utility program to change and save the new configuration information (see "Starting the Configuration/Setup Utility program" on page 12). 11. Reinstall the processor-board assembly in the server. 12. Reinstall the retention bracket. 13. Replace the two shipping thumbscrews. 14. Reinstall the memory-board assembly. AC box assembly mechanism Before you begin: v Read "Installation guidelines" on page 77. v Read the safety notices at "Safety notices (multilingual translations)" on page 201. v Read "Handling static-sensitive devices" on page 200. Complete the following steps to remove the ac box assembly mechanism: 1. Turn off the server (see "Turning off the server" on page 8), and disconnect all power cords and external cables. 2. Remove the fans (see "Replacing fan 1 or 2" on page 107). 3. Remove the top cover assembly (see "Top cover assembly" on page 137). Chapter 5. Field replaceable units 141