IBM 86884RX Maintenance Manual - Page 143
Riser card, I/O board, System, management, board, Screws from, video port, serial port, SCSI cable,
View all IBM 86884RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
12. Remove the Remote Supervisor Adapter from the riser card, disconnecting any cables, and set it in a safe place. System management board Screws from serial port Screws from video port SCSI cable Riser card I/O board 13. Remove the riser card from the I/O board, disconnecting any cables. Systemmanagement board Riser card I/O board Screws from serial port SCSI cable 14. To replace the I/O board, reverse the previous steps. 15. Restart the server; then, update the firmware (see "Updating the firmware" on page 39). If you cannot restart the server after updating the firmware, complete the following steps: 1. Attach an ANSI terminal emulator to the serial port of the Remote Supervisor Adapter of the server using a null modem cable. Use communications settings of 57600 baud, 8 data bits, no parity, 1 stop bit, no flow control. 2. Press Esc to access the login screen on the ANSI terminal emulator. A login window is displayed. Chapter 5. Field replaceable units 133