IBM 86884RX Maintenance Manual - Page 125
Field, replaceable, units
View all IBM 86884RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Chapter 5. Field replaceable units The following information describes procedures for removing and installing certain components inside the system. Only a qualified service technician is authorized to replace the components described in this section. Important: The field replaceable unit (FRU) procedures are intended for trained servicers who are familiar with IBM xSeries products. Note: Before servicing this system, read "Installation guidelines" on page 77 and "Safety information" on page 197. Memory-board assembly The memory-board assembly consists of the memory board, memory, memory-board VRM, and the memory switch card and cable. The following sections describe how to remove the memory board, memory-board VRM, and the memory switch card and cable. For instructions to remove and replace memory, see "Installing memory" on page 98. Memory board Note: When replacing the memory board, you must either update the system with the latest firmware or restore the pre-existing firmware that the customer provides on a CD image. See "Updating the firmware" on page 39. Before you begin: v Read "Installation guidelines" on page 77. v Read the safety notices at "Safety notices (multilingual translations)" on page 201. v Read "Handling static-sensitive devices" on page 200. Complete the following steps to replace a memory board: 1. Turn off the server (see "Turning off the server" on page 8), and disconnect all power cords and external cables. 2. Open the cover (see "Opening the cover" on page 88). © Copyright IBM Corp. 2003 115