IBM 86884RX Maintenance Manual - Page 13

Features and specifications The following table provides a summary of the features and specifications of your xSeries 450. Microprocessor: v Intel®™ Itanium® 2 900 MHz or higher, depending on server model v 1.5 MB (minimum) Level-3 cache v 200 MHz front-side bus (FSB), at two data transfers per cycle, yielding a 400 MHz system bus (minimum) v Support for up to four microprocessors v XceL4™ Server Accelerator Cache: 64 MB Active Memory™: v Minimum: 1 GB v Maximum: 40 GB v Type: 2-way interleaved PC2100, ECC DDR SDRAM, registered DIMMs only v Supports 512 MB, 1 GB, and 2 GB dual inline memory modules (DIMMs) Drives standard: DVD/CD-RW: IDE Expansion bays: v Two removable media bays (one DVD/CD-RW preinstalled) v Supports up to two internal Ultra320 SCSI hard disk drives Active™ PCI-X expansion slots: Six 64-bit Active PCI-X expansion slots: v Two 66 MHz PCI-X slots v Two 100 MHZ PCI-X slots v Two 133 MHZ PCI-X slots Cooling: Four hot-swap fans v Two 150 mm x 51 mm fans v Two 150 mm x 38 mm fans Acoustical noise emissions: v Declared sound power, idle: 6.5 bels v Declared sound power, operating: 6.5 bels v Bystander sound pressure, idle: 49 dBa v Bystander sound pressure, operating: 49 dBa Power supply: Two power supplies: 550 watts at 100-127 V ac or 1050 watts at 200-240 V ac (hot-swappable and redundant at 200-240 V ac only) Video: v Integrated ATI RageXL video v PCI bus interface v Compatible with SVGA v 8 MB SDRAM video memory Size (4 U): v Height: 17.8 cm (7 inches, 4 U) v Depth: 69.85 cm (27.5 inches) v Width: 48.3 cm (19 inches) v Maximum weight: 38.6 kg (85 lb), depending on your configuration Integrated functions: v Broadcom 5704 10/100/1000 dual port Ethernet controller v Light Path Diagnostics™ v One external and one internal Ultra320 SCSI port (dual-channel integrated controller with RAID capabilities) v Remote Supervisor Adapter (service processor) - ASM interconnect (peer-to-peer) port - Ethernet port - Serial port v IDE controller v RXE Management port v RXE Expansion ports v Three USB ports v SCSI ports v Serial port v Wake on LAN® Environment: v Air temperature: - Server on: 10° to 35°C (50.0° to 95.0°F). Altitude: 0 to 914 m (2998.7 ft) - Server on: 10° to 32°C (50.0° to 89.6°F). Altitude: 0 to 2133 m (6998.0 ft) - Server off: -40° to 60°C (-104° to 140°F). Maximum altitude: 2133 m (6998.0 ft) v Humidity: - Server on: 8% to 80% - Server off: 5% to 100% Heat output: Approximate heat output in British thermal units (Btu) per hour v Minimum configuration: 854 Btu (250 watts) v Maximum configuration: 2646 Btu (775 watts) Electrical input: v Sine-wave input (50-60 Hz) required v Input voltage low range: - Minimum: 100 V ac - Maximum: 127 V ac v Input voltage high range: - Minimum: 200 V ac - Maximum: 240 V ac v Input kilovolt-amperes (kVA) approximately: - Minimum: 0.250 kVA - Maximum: 1.3 kVA Notes: 1. Power consumption and heat output vary depending on the number and type of optional features installed and the power-management optional features in use. 2. These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate. Chapter 1. General information 3