IBM 86884RX Maintenance Manual - Page 130
Configuration/Setup
View all IBM 86884RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 130 highlights
5. Remove the processor-board assembly from the server: a. Press to unlock the levers securing the processor-board assembly, and pull up on the levers to release the processor-board assembly. b. Slide the assembly toward the right side of the server. c. Carefully remove the processor-board assembly from the server, and place it on a static-free, clean work surface. Levers NOTE: FOR PROPER FRONT OF BOX AIRFLOW, NOTE: FOR PROPER AIRFLOW, FRONT OF BOX REPLACE FAN WITHIN 2 MINUTES REPLACE FAN WITHIN 2 MINUTES 6. Set the processor-board assembly on a static-free, clean work surface, and remove the microprocessor assemblies and power modules that will be reused. See "Microprocessor and power module" on page 121. 7. Place the new processor-board assembly on a static-free, clean work surface, and install the microprocessors and power modules that were removed in the preceding step into the new processor board. See "Installing and replacing a microprocessor and power module" on page 100. 8. Reinstall the processor-board assembly in the server. Note: When you install or remove the processor-board assembly, the server configuration information changes. Therefore, you must use the Configuration/Setup Utility program to change and save the new configuration information (see "Starting the Configuration/Setup Utility program" on page 12). 9. Reinstall the retention bracket. 10. Replace the two shipping thumbscrews. 11. Reinstall the memory-board assembly. 120 IBM xSeries 450 Type 8688: Hardware Maintenance Manual and Troubleshooting Guide