IBM 86884RX Maintenance Manual - Page 129
Processor-board, assembly
View all IBM 86884RX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Processor-board assembly This section contains instructions for removing the processor-board assembly, the microprocessor and power module, and the processor-board VRM. Note: When replacing the processor-board assembly, you must either update the server with the latest firmware or restore the pre-existing firmware that the customer provides on a CD image. See "Updating the firmware" on page 39. Before you begin: v Read "Installation guidelines" on page 77. v Read the safety notices at "Safety notices (multilingual translations)" on page 201. v Read "Handling static-sensitive devices" on page 200. Complete the following steps to replace a processor-board assembly: 1. Turn off the server (see "Turning off the server" on page 8), and disconnect all power cords and external cables. 2. Open the cover (see "Opening the cover" on page 88). 3. Pull open the memory-board retaining latches, and remove the memory-board assembly. See "Memory board" on page 115 for details. 4. Remove the shipping thumbscrews from the right side of the server, and lift the retention bracket from the server. Lift tabs NOTE: FOR PROPER FRONT OF BOX AIRFLOW, NOTE: FOR PROPER AIRFLOW, FRONT OF BOX REPLACE FAN WITHIN 2 MINUTES REPLACE FAN WITHIN 2 MINUTES Shipping thumbscrews Chapter 5. Field replaceable units 119