Intel SE7501HG2 Product Guide - Page 46
Installing the Processor in the SC5200 Hot Swap Redundant Power Chassis,
View all Intel SE7501HG2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Installing the Processor in the SC5200 Hot Swap Redundant Power Chassis ✏ NOTE Use these instructions if you are installing a processor in the Intel® Chassis SC5200 HSRP. When using this chassis, do not install the Processor Wind Tunnel. When installing the processor in the SC5200 Base chassis or in a reference chassis, disregard this section and follow the instructions in the section titled "Installing the Processor and the Processor Wind Tunnel in the SC5200 Base Chassis or in a Reference Chassis" on page 39. Two sets of brackets included with each SC5200 HSRP chassis. For each bracket, do the following: 1. Place the bracket (letter A in the following diagram) on the server board. 2. Insert and tighten two screws (letter B in the diagram) to secure the bracket to the board. B A OM14144 Figure 17. Installing the Processor Retention Brackets 46 Intel Server Board SE7501HG2 Product Guide